e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
FIRMWARE UPDATING
11 - 16
(8) When a standard update is completed properly, "Update successfully completed Restart the
MFP" is displayed at the bottom of the LCD screen.
Notes:
When a patch update is completed, "Patch Update Successfully Restart the MFP" is displayed at
the bottom of the LCD screen.
Fig.11-12
Notes:
• “Update Failed.” is displayed at the bottom of the LCD screen when the update is not
completed properly. “Failed” appears next to the failed item on the status display. In this case,
shut down the equipment after all the updates are stopped (when either “Completed” or
“Failed” is displayed for each item), and then check the following.
- Do the USB device meet the conditions to be used for updating?
- Is the data file written properly in the USB device?
- Are the USB device installed properly?
- Do the USB device and equipment operate properly?
• When an OS update error or HDD update error occurs, “Update Failed” or “Failed” appears
on the screen and the error number appears next to the message. For details of each error,
refer to the following tables
OS update error
Error number Description
O01 FROM writing failed
O02 FROM verification error
O03 File operation error
O04 SRAM flag set error
O05 Electronic key data backup error
O06 Device error
HDD update error
Error number Description
H01 File creation error
H02 File decompression error
H03 Partition mount error
H04 Hard disk full error
H00 Other errors
To Next Page
Loading...
