Toshiba e-STUDIO 6550Ce-STUDIO 5560C - Page 1279

A K-ATS connection detection Not connected Connected
B C-ATS connection detection Not connected Connected
C M-ATS connection detection Not connected Connected
D Y-ATS connection detection Not connected Connected
E - - -
F - - -
G - - -
H - - -
A Destination judgment of fuser unit
MJC/MJD for e-
STUDIO5540C/6540
C/6550C
Others
B - - -
C - - -
Shutter motor end position detection /
Shutter sensor (end position)
(Refer to table 1)
Shutter motor home position detection /
Shutter sensor (home position)
(Refer to table 1)
F - - -
G - - -
H Pressure roller temperature abnormality Normal Excessively high
IH error signal-2
(Refer to table 2)
IH error signal-1
(Refer to table 2)
IH error signal-0
(Refer to table 2)
D - - -
E - - -
F - - -
G Image position aligning sensor (rear)
Detecting reflection
light from the belt
Not detecting
reflection light from
the belt
H Image position aligning sensor (front)
Detecting reflection
light from the belt
Not detecting
reflection light from
the belt
A Color drum phase sensor Sensor shielded Sensor not shielded
B K drum phase sensor Sensor shielded Sensor not shielded
C
Transfer belt paper clinging detection
sensor
Paper present No paper
D
2nd transfer side paper clinging
detection sensor
Paper present No paper
E - - -
F - - -
G Image position aligning sensor (Center)
Detecting reflection
light from the belt
Not detecting
reflection light from
Released
(home position)
A - - -
B Waste toner amount detection sensor Nearly full Not full
C - - -
D - - -
E
Duplexing unit opening / closing
detection sensor -LGC (Refer to table 3)
OFF(H) ON(L)
F - - -
G
Front cover opening / closing detection
switch
Cover opened Cover closed
H - - -
E OFF (H) ON (L)
OFF (H) ON (L)
C OFF (H)
[6]
[7]
D OFF (H)
ON (L)
ON (L)
[0]
[9]
H
2nd transfer roller contact / release
detection sensor
Contacted
[8]
A OFF (H) ON (L)
B