Toshiba e-STUDIO 6550Ce-STUDIO 5560C - Page 1290

129
Fuser motor (normal rotation)
ON
Normal
speed
179 Code No.129 function OFF 1
130
Bridge unit transport entrance
motor ON
Normal
speed
180 Code No.130 function OFF 1
132
Reverse motor (normal
rotation) ON
Normal
speed
182 Code No.132 function OFF 1
134
Reverse motor (reverse
rotation) ON
Normal
speed
184 Code No.134 function OFF 1
136
Bridge unit transport exit motor
(normal rotation) ON (lower
exit tray direction)
Normal
speed
186 Code No.136 function OFF 1
138
Bridge unit transport exit motor
(reverse rotation) ON (upper
exit tray direction)
Normal
speed
188 Code No.138 function OFF 1
140
Exit motor (normal rotation)
ON (lower exit tray direction)
Normal
speed
190 Code No.140 function OFF 1
142
Exit motor (reverse rotation)
ON (upper exit tray direction)
Normal
speed
192 Code No.142 function OFF 1
144 ADU motor-2 ON
Normal
speed
194 Code No.144 function OFF 1
146 ADU motor-1 ON
Normal
speed
196 Code No.146 function OFF 1
*1
Fully pull out the EPU tray toward you while the transfer belt remains. If it is not fully pulled out,
the drum shaft and the drum flange may scratch each other and thus the flange may be worn
out.
*2
1. Pull the duplexing unit lever and then separate the transfer belt and the 2nd transfer roller.
2. Pull out the EPU (developer unit) tray until it comes to a stop while the transfer belt is left.
* Pull out the EPU tray completely otherwise the transfer belt and the photoconductive
drum may scratch each other.
3. Insert a door-switch jig into the cover interlock switch on the left upper side of the fuser
unit in order not to turn the 24 V power OFF.