Toshiba e-STUDIO 6550Ce-STUDIO 5560C - Page 353

4
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
DISASSEMBLY and REPLACEMENT
4 - 179
(7) Release all the harnesses on the rear frame
side from the harness guides. Then
disconnect all the relay connectors.
Notes:
When installing, pay attention to the following
points.
• Be sure that the AC harness (thick line)
[1] is routed above the harness guide and
fixed with 3 hooks [2], and the DC
harness (thin line) [3] is routed under the
harness guide and fixed with 4 hooks [4].
• Be sure that the pressure roller heater
lamp harness does not go onto the bent
portion of the metal plate [1].
• Be sure that the connector [2] of the
pressure roller heater lamp harness is
fixed to the inner side with a latch [3].
Fig. 4-515
Fig. 4-516
(8) Remove 1 screw and then take off the rear
lamp bracket [1].
Fig. 4-517
(9) Remove 2 screws and release the harness
from 2 clamps.
Notes:
When installing, be sure to fix the harness
securely with 2 clamps.
Fig. 4-518
[
1
]
[
2
]
[
3
]
[
4
]
[
4
]
[
1
]
[
1
]
[
2
]
[
3
]
[
1
]