4
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
DISASSEMBLY and REPLACEMENT
4 - 185
(11) Turn the fuser unit by 90 degrees, and raise
the fuser belt [1] to take it off.
Notes:
Be sure not to disassemble the holder
retaining the fuser belt unit in the fuser unit
since it is adjusted with the jig.
Fig. 4-535
Fig. 4-536
(12) Remove 1 E-ring each on both sides of the
fuser roller. Then take off the fuser belt
guide.
Fig. 4-537
Fuser belt guide
Fuser belt guide
E-ring
E-ring
To Next Page
Loading...
