e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY and REPLACEMENT
4 - 246
(7) Remove 2 screw and take off the front hook.
Notes:
The type of screw differs depending on its
installation position.
Fig. 4-714
(8) Remove 2 E-rings, 2 pulleys, 2 belts, 1
bushing and a bracket.
Fig. 4-715
(9) Remove a clip from the front side of the lever
shaft. Then take off a bushing.
Fig. 4-716
(10) Take off the lever shaft from the rear side.
Fig. 4-717
To Next Page
Loading...
