8
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
ERROR CODE and TROUBLESHOOTING
8 - 93
[EA32] Exit paper remaining jam
[EA40] Door open jam
Check item Measures
Finisher • Check if there is any paper in the finisher or on the
transport path of the equipment and remove it if there is.
Transport sensor (S2) • Sensor check
• Connector check
• Harness check
Finisher controller board • Connector check(CN11)
• Board check
Replace parts Remarks
Transport sensor (S2)
Finisher controller board
Classification Error item
Finisher jam
(Finisher section)
The paper is remaining on the finishing tray when the power
is turned ON. [MJ-1103/1104]
Check item Measures
Finisher • Check if there is any paper in the finisher or on the
transport path of the equipment and remove it if there is.
Finishing tray paper detection sensor
(S12)
• Sensor check
• Connector check
• Harness check
Finisher controller board • Connector check(CN11)
• Board check
Replace parts Remarks
Finishing tray paper detection sensor
(S12)
Finisher controller board
Classification Error item
Finisher jam
(Finisher section)
The front cover or stationary tray cover is opened during
paper transport. [MJ-1103/1104]
Check item Measures
Cover • Close the front cover or the stationary tray cover if they are
opened.
Front cover switch (SW1) • Sensor check
• Connector check
• Harness check
Stationary tray opening/closing
switch (SW2)
• Sensor check
• Connector check
• Harness check
To Next Page
Loading...
