8
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
ERROR CODE and TROUBLESHOOTING
8 - 197
[F106_5] ADI-HDD error: Authentication data transmission error
[F106_6]/[F106_7]/[F106_8]/[F106_10] /[F106_UNDEF] ADI-HDD error: Error caused by reason
other than F106_0 to 5 errors
[F109_0] Key consistency error (Consistency check operation error)
Classification Error item
Other service call ADI-HDD error: The transmission of authentication data fails.
Check Item Measure
Setting Reinstall the system ROM data (OS Data).
Reinstall the master data (HD Data).
• In case this error occurred after returning SRAM data for
SRAM cloning:
Copy the ADI-HDD encryption key from FROM to SRAM.
(1) Start the equipment in the 3C mode: [3] + [C] + [POWER]
(2) The authentication menu is displayed. Press [OK]. (Not
required in the default setting)
(3) Select “5. Key Backup Restore” and then press the
[START] button.
(4) Select “6. ADIKey FROM to SRAM” and then press the
[START] button.
(5) After the restoring of the encryption key has completed,
“Operation Complete” is displayed.
(6) After the operation has completed, shut down the
equipment by pressing the [POWER] button.
HDD If the error persists even after above step, replace the HDD. If
the equipment operation disabled after above step, replace the
HDD.
Classification Error item
Other service call ADI-HDD error: Error caused by reason other than F106_0 to 5
errors
Check Item Measure
Setting Perform [3]+[C]+[POWER]-> [3.Format HDD], and then install
the system software by performing [4]+[9]+[POWER]->
[4.System Software(HD data)].
Notes:
The following items will be deleted by performing
[3]+[C]+[POWER]-> [3.Format HDD].
• Message Log
•Job Log
• Spool Data (Print, Email reception)
• Template
HDD If the error persists even after above step, replace the HDD. If
the equipment operation disabled after above step, replace the
HDD.
Classification Contents
Other service call Key consistency error - Key consistency check on each key
data fails.