e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE and TROUBLESHOOTING
8 - 242
[2E45] Meta data creation error in USB storage (Scan to File)
[2E65] File creation error due to insufficient USB folder capacity
[2E66] HDD full failure in USB storage
[2EC1] Power failure in USB storage
Replace parts Remarks
Classification Error item
File sharing related error Creation of meta data failed.
Check item Measures
Setting Check the template settings. Perform the job in error again. If
the error still occurs, turn the power OFF and then back ON,
and then perform the job in error again.
Replace parts Remarks
Classification Error item
File sharing related error Creation of a new file failed because there were too many
files in the USB folder
Check item Measures
Setting Delete unnecessary files in the folder.
Replace parts Remarks
Classification Error item
File sharing related error HDD became full while storing data in HDD.
Check item Measures
Setting Delete the job in progress or being set or in the HOLD/
PRIVATE/PROOF/INVALID, and perform it again.
Check if the server or local disk has a sufficient space in disk
capacity.
Check that there is enough space in the USB memory.
Replace parts Remarks
Classification Error item
File sharing related error Power failure occurred.
To Next Page
Loading...
