NEC Univerge SV8100 - Page 213

UNIVERGE SV8100 Issue 10.1
Programming Manual 2 - 177
02
Trunk Ring Tone
Use this option to set the tone
(pitch) of the incoming trunk ring for
the extension port you are
programming.
 DTU/DTP-style telephones only
follow high, medium and low
range ring tone settings. They do
not follow Melodies.
1 = High
2 = Medium
3=Low
4 = Ring Tone 1
5 = Ring Tone 2
6 = Ring Tone 3
7 = Ring Tone 4
8 = Ring Tone 5
2 22-03
03
Extension Ring Tone
Use this option to set the tone
(pitch) of the incoming extension
call ring for the extension port you
are programming. Also refer to
Program 15-08.
 DTU/DTP style telephones only
follow high, medium and low
range ring tone settings. They do
not follow Melodies.
1 = High
2 = Medium
3=Low
4 = Ring Tone 1
5 = Ring Tone 2
6 = Ring Tone 3
7 = Ring Tone 4
8 = Ring Tone 5
8
04
Redial (Speed Dial) Control
Use this option to control the
function of the extension Redial
key when used with Speed Dialing.
The Redial key can access either
the Common/Individual or Group
Speed Dialing numbers.
0 = Common Speed Dialing
1 = Group Speed Dialing
0
05
Transfer Key Operation Mode
Use this option to set the operating
mode of the extension CONF key.
The keys can be for Call Transfer,
Serial Calling or Flash. When
selecting the Flash option
(selection 2), refer also to Program
81-01-14.
0=Transfer
1 = Call back
2 = Hook
0
06
Hold Key Operating Mode
Use this option to set the function
of the Multiline Hold key. The Hold
key can activate normal Hold or
Exclusive Hold.
0 = Normal (Common)
1 = Exclusive Hold
2 = Park Hold (OT)
0
07
Automatic Hold for CO Lines
When talking on a CO call and
another CO line key is pressed, the
original trunk is placed on Hold (0)
or Disconnected (1).
0 = Hold
1 = Disconnect (Cut)
1
Item
No.
Item Input Data Default
Related
Program