NEC Univerge SV8100 - Page 235

UNIVERGE SV8100 Issue 10.1
Programming Manual 2 - 199
Default
Programmable keys 1~8 are Trunk Line keys (key 1 = Trunk Line 1, key 2 = Trunk Line 2,
etc.). All other programmable keys are undefined.
Function Number List
[1] Normal Function Code (00 ~ 99) (Service Code 851 (OT) / 751 (AU))
Item
No.
Line Key
Number
Function Number Additional Data
01 1~48 0~99
(Normal Function Code) (Service Code 851 (OT) /
751 (AU) by default)
* 00 ~ *99
(Appearance Function Code) (Service Code 852
(OT) / 752 (AU) by default)
Refer to Function
Number List.
Function Number List
[1] Normal Function Code (00 ~ 99) (Service Code 851 (OT) / 751(AU))
Function
Number
Function Additional Data LED Indication
00
--- Not Used ---
01
DSS/One-Touch
Extension number
or any numbers (up
to 24 digits)
Red On: Extension Busy
Off: Extension Idle
Rapid Blink (Red): DND or Call
Forward
02
Microphone Key
(ON/OFF)
Red On: Mic Off
Off: Mic On
03
DND Key
Red On: DND
04
BGM (ON/OFF)
Red On: BGM On
Off: BGM Off
05
Headset
Red On: Headset in use
06
Transfer Key
None
07
Conference Key
Red On: Conference call setup
occurring
08
Incoming Call Log
Rapid Blink (Red): New call log
Red On: Call log
Off: No call log
09
Day/Night Mode
Switch
Mode number (1~8)
(0 =toggle)
Red On: Mode active