NEC Univerge SV8100 - Page 277

UNIVERGE SV8100 Issue 10.1
Programming Manual 2 - 241
11
Handsfree
Microphone Control
Use this option to
control the setting for
Multiline Terminal
Handsfree microphone
after being
disconnected and
reconnected. If set to
0, the microphone is
always off when the
terminal is
reconnected. If set to
1, the microphone
remains in the same
state it was in when
the terminal is
reconnected.
0=Off
1=On
1
12
Forced Intercom
Ring (ICM Call Type)
Use this option to
enable or disable
Forced Intercom
Ringing. If enabled,
incoming Intercom
calls normally ring. If
disabled, Intercom
calls voice-announce.
0 = Disable (Voice)
1 = Enable (Signal)
0 (OT)
1 (AU)
15
Caller ID Display
Mode
0 = Name and Number (Both)
1=Name
2 = Number
0
18
Dialing Record
Display Time
0~64800 seconds
30s
19
DSS Key - Virtual
Extension Mode
Sets the mode of a
virtual extension key
that appears on a DSS
console.Setting this
PRG to 1 (Yes) will
disable DSS function
of DSS/BLF keys.
0 = No
1 = Yes
0
23
CAP/Loop Key
Operation Mode (OT)
0…CAP Key Operation Mode
1…Loop Key Operation Mode
1
Input Data (Continued)
Item
No.
Item Input Data Default
Related
Program