NEC Univerge SV8100 - Page 354

Issue 10.1 UNIVERGE SV8100
2 - 318 Program 21 : Outgoing Call Setup
12
PBX Call
Restriction
0=Disable
(No)
1=Enable
(Yes)
1~6, 8~15 =
0
7 = 1
Use this option to set how
the system Toll Restricts
calls over PBX trunks. If you
enable PBX Toll Restriction,
the system begins Toll
Restriction after the PBX
access code. The user
cannot dial a PBX extension.
If you disable PBX Toll
Restriction, the system only
restricts calls that contain
the PBX access code. The
system does not restrict
calls to PBX extensions.
Refer to the PBX
compatibility feature. Make
sure Program 21-05-04
(Maximum Number of Digits
Table Assignment) allows for
PBX Toll Call Dialing
(normally 12 digits).
13
Restriction of Tie
Line Calls
0=Disable
(No)
1=Enable
(Yes)
0
It chooses whether the toll
restriction of the dial set up
by 34-08 is enabled or
disabled.
34-08
14
Trunk Transfer
Restriction on
Incomplete Dial
0 = Not allow
1=Allow
0
If this program is set to 1,
you can transfer the
outgoing trunk which you
dialed incompletely.
15
Common Hold
Restriction on
Incomplete Dial
0 = Not allow
1=Allow
0
If this program is set to 1,
you can hold the outgoing
trunk which you dialed in
restriction check.
Item
No.
Item Input Data Default Description
Related
PRG