NEC Univerge SV8100 - Backing Up the VM8000 InMail CompactFlash Card

Issue 10.1 UNIVERGE SV8100
2 - 470 Program 35 : SMDR Account Code Setup
07
Toll Charge Cost
Set this option to (1) have the SMDR report include
toll charges.
0 = Not Displayed
1 = Displayed
1
08
Incoming Call
Enable this option (1) to have the SMDR report
include incoming calls. If you disable this option (0),
incoming calls do not print.
0 = Not Displayed
1 = Displayed
1
09
Extension Number or Name
Set this option (1) to have the SMDR report include
extension numbers. Set this option (0) to have the
SMDR report include extension names.
0=Name
1=Number
0 (OT)
1 (AU)
10
All Lines Busy (ALB) Output
Determine if the All Lines Busy (ALB) indication
should be displayed.
0 = Not Displayed
1 = Displayed
0
11
Walking Toll Restriction Table Number
0 = Not Output
1=Output
1
12
DID Table Name Output
Determine if the DID table name should be
displayed.
0 = Not Displayed
1 = Displayed
0
13
CLI Output When DID to Trunk
Determine if the CLI output should be displayed for
DID.
0 = Not Displayed
1 = Displayed
0
14
Date
Determine whether or not the date should be
displayed on SMDR reports.
 This option must be set to 0 if the trunk name is
set to be displayed in Program 35-02-03.
0 = Not Displayed
1 = Displayed
0
15
CLI/DID Number Switching
Determine whether or not the CLI/DID Number
Switching should be displayed.
0=CLI (CLIP)
1 = DID Calling
Number
0
16
Trunk Name or Received Dialed Number
Determine how the SMDR should print incoming calls
on ANI/DNIS or DID trunks. If set to (1), ANI/DNIS
trunks can print DNIS digits. If set to (0) trunk names
are printed instead.
0 = Trunk Port Name
1 = Received Dialed
Number
2=Both (OT)
0
17
Print Account Code or Caller Name of Incoming
Call
Determine if SMDR should print Account Code or
Caller Name of Incoming Call.
0=ACC
1 = CNAME
0
18
Print Mode for Caller Name of Incoming Call
Determine how SMDR should print Caller Name of
Incoming Call.
0 = Normal
1 = Line Feed
0
Item
No.
Item Input Data Default