NEC Univerge SV8100 - Page 507

UNIVERGE SV8100 Issue 10.1
Programming Manual 2 - 471
Conditions
None
Feature Cross Reference
 Station Message Detail Recording
19
Dialed Number Output Format (OT)
Determine if the dialed number should display the
first 20 digits or the last 20 digits. This option is only
available for outgoing calls.
0 = First 20 Digits
1 = Last 20 Digits
0
20
External Information CFW Mode (OT)
Determine which information is displayed in the
“STATION” area for a transferred call when the
extension has Call Forward set with an Abbreviated
Dial number as the destination. Selecting “0”
(Transfer Info) will display the extension number
which called the extension with external Call
Forward set. Selecting “1” (Incoming Info) will display
the extension number which has the external Call
Forward set.
This option only applies when Call Forward is set
using a service code (Program 11-11-01~11-11-07)
and the destination uses an Abbreviated Dial bin. It
does not include Off-Premise or Centrex transfers.
0 = Transfer
Information
1 = Incoming
Information
0
21
S-Point Terminal Number
0=MSN Number
1 = Extension
Number
0
22
Security Auto Dialing
0 = No Output
1 = Output
0
23
Watch Auto Dialing
0 = No Output
1 = Output
0
24
Mark Virtual Loop (Not Used)
Define whether calls routed via the ISDN Virtual
Loopback are tagged.
0 = Don’t mark
1 = Mark
0
Item
No.
Item Input Data Default