• Manually swap the APs
Options for Provisioning and Swapping APs
The controller supports the provisioning and swapping of access points.
Use the following buttons on the AP List page to perform the AP provisioning and swapping.
• Import Batch Provisioning APs: Click this button to import the provisioning file. The controller
displays the import results. Any errors that occur during the import process will be listed by
the controller.
• Export All Batch Provisioning APs: Click this button to download a CSV file that lists all
APs that have been provisioned. The exported CSV contains the following information:
• AP MAC Address
• Zone Name
• Model
• AP Name
• Description
• Location
• GPS Coordinates
• Logon ID
• Password
• Administrative State
• IP Address
• Network Mask
• Gateway
• Primary DNS
• Secondary DNS
NOTE: The exported CSV file for all batch provisioned APs only contains pre-provisioned
APs. It does not contain swapping APs or auto discovered APs.
If no APs have been pre-provisioned, you will still be able to export the CSV file but it will
be empty (except for the column titles).
• Import Swapping APs: Manually trigger the swapping of two APs by clicking the swap action
in the row. You can also edit the pre-provision configuration only if the AP does not connect
to the controller. Click the AP MAC address to bring up the configuration edit form, and then
select Pre-provision Configuration.
• Export All Batch Swapping APs: Click this button to download a CSV file that lists all APs
that have been swapped. The exported CSV contains the following information:
• Swap In AP MAC
• Swap In AP Model
• Swap Out AP MAC
NOTE: The exported CSV file for batch swapping APs only contains swapping APs. It
does not contain pre-provisioned APs or auto discovered APs.
SmartCell Gateway 200/Virtual SmartZone High-Scale for Release 3.4.1 Administrator Guide
145
Managing Access Points
Provisioning and Swapping Access Points
To Next Page
Loading...
