7
Configuring the System Settings
In this chapter:
• Overview of the System Settings
• Configuring General System Settings
• Configuring Cluster Planes
• Configuring Network Management
• Configuring Hosted AAA Services
In this chapter:
Overview of the System Settings
System settings refer to general controller settings, network management settings, and plane
settings.
Configuring General System Settings
To configure the general settings, go to the Configuration > System page, and then click
General System Settings on the sidebar. Configuration tasks under general settings include:
Setting the System Time
The controller uses an external network time protocol (NTP) server to synchronize the times
across cluster nodes and managed access points.
Follow these steps to set the system time.
1. Go to Configuration > System.
2. Under General System Settings, click System Time.
3. In NTP Server, type the server address that you want to use. The default NTP server address
is pool.ntp.org.
4. In System Time Zone, select the time zone that you want the controller to use. The default
time zone is (GMT +0:00) UTC.
5. Click Apply.
SmartCell Gateway 200/Virtual SmartZone High-Scale for Release 3.4.1 Administrator Guide
203
203
To Next Page
Loading...
