1
Navigating the Web Interface
In this chapter:
• Setting Up the Controller for the First Time
• Logging On to the Web Interface
• Web Interface Features
• Using Widgets on the Dashboard
• Changing the Administrator Password
• Logging Off the Web Interface
In this chapter:
NOTE: Before continuing, make sure that you have already set up the controller on the network as
described in the Getting Started Guide or Quick Setup Guide for your controller platform.
Some of the new features (for example, location based services, rogue AP detection, force DHCP,
and others) that this guide describes may not be visible on the controller web interface if the AP
firmware deployed to the zone you are configuring is earlier than this release. To ensure that you can
view and configure all new features that are available in this release, Ruckus Wireless recommends
upgrading the AP firmware to the latest version.
Setting Up the Controller for the First Time
For information on how to set up the controller for the first time, including instructions for running
and completing the controller's Setup Wizard, see the Getting Started Guide or Quick Setup
Guide for your controller platform.
Logging On to the Web Interface
Before you can log on to the controller web interface, you must have the IP address that you
assigned to the Management (Web) interface when you set up the controller on the network
using the Setup Wizard.
Once you have this IP address, you can access the web interface on any computer that can
reach the Management (Web) interface on the IP network.
Follow these steps to log on to the controller web interface.
1. On a computer that is on the same subnet as the Management (Web) interface, start a web
browser. Supported web browsers include:
• Google Chrome 15 (and later) - recommended
• Microsoft Internet Explorer 9.0
• Safari 5.1.1 (and later)
SmartCell Gateway 200/Virtual SmartZone High-Scale for Release 3.4.1 Administrator Guide
19
19
To Next Page
Loading...
