Ruckus Wireless Virtual SmartZone - Working with Forwarding Profiles; Creating an L2 oGRE Profile

Deleting DNS Server Services Profile
Follow these steps to delete the DNS server services profiles.
1. Go to Configuration > Services & Profiles > Service Profiles > DNS Server Services.
The DNS Server Services page appears.
2. Locate the profile or profiles that you want to delete.
3. Select the check boxes (first column) for the profiles that you want to delete.
4. Click Delete Selected.
The profiles that you selected disappear from the list. You have completed deleting the profiles.
Working with Forwarding Profiles
This sections covers:
L2oGRE Profiles
An L2oGRE forwarding profile defines the gateway and tunnel configuration for the core network
of L2oGRE tunnels. This section covers:
Creating an L2oGRE Profile
An L2oGRE forwarding profile defines the gateway and tunnel configuration for the core network
of L2oGRE tunnels.
Follow these steps to add an L2oGRE profile.
1. Go to Configuration > Services & Profiles.
2. On the sidebar under Profiles > Forwarding, click L2oGRE.
The L2oGRE Forwarding Profiles page appears.
3. Click Create New.
The Create New L2oGRE Profile form appears.
4. In Name, type a name for the L2oGRE profile that you are creating.
5. In Description, type a brief description of the profile.
This is an optional field.
6. In Core Network Gateway Settings, configure the following:
a) Primary Gateway IP: Type the IP address of the primary gateway for the L2oGRE tunnel.
b) Secondary Gateway IP: Type the IP address of the secondary gateway for the L2oGRE
tunnel. If the primary gateway is unreachable, this gateway will be used for the L2oGRE
tunnel.
c) Gateway Path MTU: Set it the MTU manually or use Auto (default). MTU is the size of
the largest protocol data unit (in bytes) that can be passed on the controller network.
d) ICMP Keep-Alive Period (secs): Set the time in seconds between sending retry messages
to the keepalive IP address. Enter an integer between 2 and 255. The default is 10 seconds.
e) ICMP Keep-Alive Retry: Set the retry period to send messages to the keepalive IP address.
The default value is 3 retries.
7. In DHCP Relay, configure the following options to enable the DHCP relay agent in the
controller:
SmartCell Gateway 200/Virtual SmartZone High-Scale for Release 3.4.1 Administrator Guide
189
Configuring Services and Profiles
Working with Profiles