Ruckus Wireless Virtual SmartZone - Using the Search Criteria Section

Table 17: Alarm details (Continued) on page 305 lists the alarm details that are displayed on the
Alarms page.
Table 17: Alarm details (Continued)
DescriptionColumn Name
Date and time when the alarm was triggeredDate and Time
Alarm code (see the Alarm and Reference Guide for your controller
platform for more information)
Code
Type of alarm event that occurred (for example, AP reset to factory
settings)
Alarm Type
Severity level assigned to the alarm. Possible values include (from most
severe to least severe):
Critical
Severity
Major
Minor
Warning
Indicates whether the alarm has already been cleared or still outstandingStatus
Date and time when you or another administrator acknowledge the
alarm
Acknowledged On
Displays additional details about the alarm, including (if available) the
specific access point, control plane, or data plane that triggered the
alarm
Activity
Icons for actions that you can perform, including:
– Click this to take ownership of issue. Acknowledging an alarm lets
other administrators know that someone is already looking into the
issue.
Actions
– Click this to clear the alarm. You may clear an alarm to let other
administrators know that you have already resolved the issue. When
you click this icon, a text box appears where you can enter comments
or notes about the resolved issue. Click Clear when done.
Using the Search Criteria Section
By default, the controller displays alarms triggered on all access points (using All APs as the
search criteria) when you load the Alarms page.
If you want to filter the alarms that are displayed on the page (for example, you want to display
only critical alarms), use the Search Criteria section.
SmartCell Gateway 200/Virtual SmartZone High-Scale for Release 3.4.1 Administrator Guide
305
Monitoring the System, Alarms, Events, and Administrator Activity
Viewing Alarms