14
Working with Reports
In this chapter:
• Types of Reports
• Creating a New Report
• Viewing a List of Existing Reports
• Deleting a Report
Types of Reports
The controller provides the following types of reports:
NOTE: If you download a CSV report created by SCG, the file naming convention is as follows:
<report title>-YYYY-MM-DD_HH-MM-SS-MS_ZZ
where
MS stands for three-digit milliseconds.
ZZ is a random number to avoid the file name conflict when a user subscribes to several reports
but based on the same filter. ZZ ranges between 00-99.
For example: New_Client-2015-11-17_08-00-16-031_59.csv
Active TTG Sessions Report
The Active TTG Sessions report shows a historical view of the number of active TTG sessions
established in the controller.
The active TTG session report can be shown in different time intervals for a specified duration.
The report can be generated based on specific control planes or GGSN IP addresses.
Client Number Report
This Client Number Report shows a historical view of the maximum and minimum number of
clients connect to the system.
Client number can be shown in different time intervals for a specified duration. The report can
be generated based on specific management domain, AP zone, AP, SSID, or radio type.
Client Number vs Airtime Report
This Client Number vs Airtime Report shows a historical view of the average number of clients
connected to the system and the corresponding airtime (TX, RX, Busy).
Client number and airtime can be shown in different time intervals for a specified duration. The
report can be generated based on a specific management domain, AP zone, AP, SSID, or radio
type.
SmartCell Gateway 200/Virtual SmartZone High-Scale for Release 3.4.1 Administrator Guide
315
315
To Next Page
Loading...
Need help?
General
