Figure 164: Page showing the wireless client information
Measuring Wireless Network Throughput with SpeedFlex
SpeedFlex is a wireless performance tool included in the controller that you can use to measure
the downlink throughput between the controller and an AP.
When performing a site survey, you can use SpeedFlex to help find the optimum location for
APs on the network with respect to user locations.
NOTE: SpeedFlex is unable to measure the throughput between two devices if those two devices
are not on the same VLAN or the same subnet.
Follow these steps to measure the throughput of an AP from the controller web interface.
1. Find out the MAC address of the AP that you want to use for this test procedure.
2. Log on to the controller web interface.
3. If you want to test AP throughput, click Monitor > Access Points.
SmartCell Gateway 200/Virtual SmartZone High-Scale for Release 3.4.1 Administrator Guide
298
Monitoring AP Zones, Access Points, and Wireless Clients
Monitoring Wireless Clients
To Next Page
Loading...
Need help?
General
