You have completed adding an FTP server to the controller. You may add additional FTP servers
as required.
Figure 70: Adding an FTP server to the controller
Important Notes When Adding FTP Servers
If you are adding an FTP server to the controller, take note of these changes that were made in
later releases.
Remember the following important notes when configuring FTP services in release 2.5 (and
later).
• Duplicate FTP servers are not allowed in release 2.5 (and later). For example, you cannot add
172.19.7.23 as one FTP server and 172.19.7.23/temp (/temp is the remote directory)
as another.
NOTE: /temp refers to /home, /admin or /temp in that server. If /temp does not follow the
server IP address (such as 172.19.7.23/temp), it indicates that the FTP directory is /home or
/admin. Here, admin refers to the username that is configured in the new FTP server.
• FTP servers must be added on the Configuration > Services & Profiles > FTPpage. The
FTP servers that you add on this page will appear as options on the following pages:
• Configuration > Services & Profiles > Services > CGF services > Auto Export
FTP > Binary File Options
• System > FTP Server for Uploading Statistics
• Reports > Export Report Results
• System Configuration Backup and Restore > Auto Export Backup
• If, before the controller was upgraded to 2.5 (or later version), statistics upload, CGF server
binary files, reports, and system configuration backup were configured to be uploaded to
four different FTP servers, then after upgrading to 2.5 (or later version), the controller will
automatically create entries for those four FTP servers on the Configuration > Services &
Profiles > FTPpage.
SmartCell Gateway 200/Virtual SmartZone High-Scale for Release 3.4.1 Administrator Guide
166
Configuring Services and Profiles
Configuring FTP Services
To Next Page
Loading...
Need help?
General
