Working with Guest Access Portals
Using the controller’s guest access features, you can provide visitors to your organization limited
access to a guest WLAN with configurable guest policies.
The following sections describe how to configure guest WLANs and access policies that control
guest use of your network.
Creating a Guest Access Portal
Each guest WLAN must be associated with a guest access portal, which defines the behavior
of the guest WLAN interface.
Follow these steps to create a guest access portal.
1. Click Configuration > AP Zones.
2. On the AP Zone List page, click the AP zone for which you want to create a guest access
portal.
The Guest Access Portal page appears.
3. Click Create New.
The Create New Guest Access Portal form appears.
4. In General Options, configure the following:
• Portal Name: Type a name for the guest access portal that you are creating.
• Portal Description: Type a short description of the guest access portal.
• Language: Select the display language to use for the buttons on the guest access logon
page.
5. In Redirection, select where to redirect the user after successfully completing authentication.
• Redirect to the URL that the user intends to visit: Allows the guest user to continue to their
destination without redirection.
• Redirect to the following URL: Redirect the user to a specified web page (entered into the
text box) prior to forwarding them to their destination. When guest users land on this page,
they are shown the expiration time for their guest pass.
6. In Guest Access, configure the following options:
• Guest Pass SMS Gateway: You can deliver the guest pass to the user using Short
Message Service (SMS). But first, you need to configure an SMS server. For more
information, see Configuring an SMS Server on page 170. If you previously configured an
SMS server, you can select it here or you can click Disabled.
• Terms And Conditions: To require users to read and accept your terms and conditions
prior to use of the guest hotspot, select the Show Terms And Conditions check box.
The box below, which contains the default Terms of Use text, becomes editable. Edit the
text or leave it unchanged to use the default text.
• Web Portal Logo: By default, the guest hotspot logon page displays the Ruckus Wireless
logo. To use your own logo, click the Upload button, select your logo (recommended size
is 138 x 40 pixels, maximum file size is 20KB), and then click Upload.
SmartCell Gateway 200/Virtual SmartZone High-Scale for Release 3.4.1 Administrator Guide
62
Managing Ruckus Wireless AP Zones
Working with Guest Access Portals
To Next Page
Loading...
