Creating a Hotspot Portal
Settings that you need to configure a hotspot service in the zone template.
Follow these steps to configure the hotspot service of the zone template.
1. Click Configuration > AP Zones.
2. On the AP Zone List page, click the AP zone for which you want to create a hotspot service.
3. On the sidebar, click Hotspot (WISPr).
The Hotspot (WISPr) Portal page appears.
4. Click Create New.
The form for creating a new hotspot portal appears.
5. In the General Options section, configure the following options:
• Name: Type a name for the hotspot portal.
• Description: Type a description for the hotspot portal.
6. In the Redirection section, configure the following options:
• Smart Client Support: Select one of the following options:
• None: Select this option to disable Smart Client support on the hotspot portal.
• Enable: Selection this option to enable Smart Client support.
• Only Smart Client Allowed: Select this option to allow only Smart Clients to connect to
the hotspot portal. For more information, see Configuring Smart Client Support on page
279.
• Logon URL: Type the URL of the subscriber portal (the page where hotspot users can log
in to access the service). For more information, see Configuring the Hotspot Logon URL
on page 279.
• Start Page: Set where users will be redirected after they log in successfully:
• Redirect to the URL that user intends to visit: You could redirect users to the page that
they want to visit.
• Redirect to the following URL: You could set a different page where users will be
redirected (for example, your company website).
7. In the User Session section, configure the following options:
• Session Timeout: Set a time limit (in minutes) after which users will be disconnected from
the hotspot portal and will be required to log on again.
• Grace Period: Set the time period (in minutes) during which disconnected users are allowed
access to the hotspot portal without having to log on again.
8. In the Location Information section, configure the following options:
• Location ID: Type the ISO and ITU country and area code that the AP includes in accounting
and authentication requests. The required code includes:
• isocc (ISO-country-code): The ISO country code that the AP includes in RADIUS
authentication and accounting requests.
SmartCell Gateway 200/Virtual SmartZone High-Scale for Release 3.4.1 Administrator Guide
59
Managing Ruckus Wireless AP Zones
Working with Hotspot (WISPr) Portals
To Next Page
Loading...
