Configuring Remote Peer Settings
The controller supports the 3GPP STa interface for EAP-SIM to authenticate and authorize
subscribers.
Follow these steps to configure the remote peer settings for the Diameter services.
1. Go to Configuration > Services & Profiles.
2. On the sidebar, click Remote Peer Configuration under Diameter Services.
The Remote Diameter Services page appears.
3. Click Create New.
The Create Remote Diameter Peer Configuration form appears.
4. In Service Name, type a name for the service you are creating.
5. In Description, type a brief description of the service.
6. In General Settings, configure the following options:
• Server Realm Name: Type name realm name of the server.
• Service Type: Select the type of Diameter service. Options include:
• DRA (Diameter Routing Agents)
• OCS (Online Charging Systems)
• PCRF (Policy and Charging Rules Functions)
• STA
If you select PCRF or STA, you will need to configure the Tx Timer (in seconds) and
Retransmit Count settings as well.
7. In Peers, add a peer entity to associate with the current Diameter remote peer settings by
filling out the following boxes:
• Peer Name
• IP Address
• Port
• Transport Type
• Alternate Pee > r
a) Click Save to add this peer entity to the remote peer settings.
b) To add another peer entity, click Create New in the Peers section, and then fill out the
new set of boxes that appear.
8. Click Create New at the bottom of the page to create the remote peer configuration.
You have completed configuring the remote peer settings for the Diameter services.
SmartCell Gateway 200/Virtual SmartZone High-Scale for Release 3.4.1 Administrator Guide
164
Configuring Services and Profiles
Configuring Diameter Services
To Next Page
Loading...
