• SNMP agent
• Alarm to SNMP agent
• Cluster planes
• Management interface ACL
• Domain information
• User credentials and information
• Mobile Virtual Network Operators (MVNO) information
Backing Up Configuration
There are two methods you can use to back up the controller configuration:
Backing Up Configuration from the Web Interface
For information on how to back up the controller configuration to an external FTP server
automatically, see Exporting the Configuration Backup to an FTP Server Automatically on page
353.
Backing Up Configuration from the CLI
There are two methods you can use to back up the controller configuration either using the web
interface or CLI (Command Line Interface).
Follow these steps to back up the controller configuration from the CLI.
1. Log on to the controller CLI as a system administrator.
2. Run the enable command to enable privileged mode on the CLI.
ruckus> enable
Password: ********
ruckus#
3. Run the backup config command to start backing up and transferring the node
configuration to an FTP server.
ruckus# backup config {ftp username} {ftp password}
{ftp server address} {(optional) ftp server port}
Do you want to backup configuration (yes/no)? yes
Backup Configuration process starts
Backup Configuration process has been scheduled to run. You can
check backup version using 'show backup-config'
4. Run the show backup-config command to verify that the backup file has been created.
You have completed backing up the controller node to an external FTP server.
Restoring Configuration
Restoring Configuration to a Single Node Environment
Restoring the configured backup in a single node environment.
Follow the steps below to restore configuration to a single node environment.
1. Prepare the new controller to which you will restore the cluster backup.
SmartCell Gateway 200/Virtual SmartZone High-Scale for Release 3.4.1 Administrator Guide
458
Replacing a Controller Node
Backing Up and Restoring Configuration
To Next Page
Loading...
