a) Either obtain a new controller or factory reset an existing controller.
b) Log on to the controller as a system administrator.
c) Run the setup command to configure the controller's network settings.
ruckus> setup
################################################
Start SCG setup process:
################################################
:
:
Setup configuration of ethers...
Network would be restarted. You could connect to SCG back by
using Management port (10.2.2.35)!!
Enter "restart network" to continue... restart network
d) Complete the controller setup process from the CLI.
2. After you complete the controller setup, log on to the controller web interface as a system
administrator.
3. Go to Administration > Configuration Backup and Restore.
4. In the Configuration Backups section, click the Upload icon.
5. Browse to the location (either on the local computer or on the network) of the configuration
backup file that you want to restore.
6. Select the configuration backup file, and then click Upload.
When the upload process is complete, the backup file appears in the Configuration Backups
section.
7. Restore the configuration backup file to the node, either using the web interface or the CLI.
8. To use the web interface:
a) On the web interface, go to Administration > Configuration Backup and Restore.
b) In Configuration Backups, locate the configuration backup file that you want to restore,
and then click the restore icon that is in the same row.
c) Follow the prompts (if any) to complete the restore process.
9. To use the CLI:
a) Log on to the CLI as a system administrator.
b) Run the restore config command.
ruckus# restore config
This action will REBOOT the system. Do you want to only restore
this SCG node (yes/no)?yes
idx version date
------------------------------------------
1 1.1.1.0.93 2013-02-01 03:09:27 GMT
2 1.1.1.0.93 2013-02-03 07:21:24 GMT
Please choose a backup version to restore (ex: 1, 2, ...):2
c) Follow the prompts (if any) to complete the restore process.
You have completed restoring the configuration to a single node controller.
SmartCell Gateway 200/Virtual SmartZone High-Scale for Release 3.4.1 Administrator Guide
459
Replacing a Controller Node
Backing Up and Restoring Configuration
To Next Page
Loading...
