13
Monitoring the System, Alarms, Events,
and Administrator Activity
In this chapter:
• Monitoring the Controller System
• Monitoring Rogue Access Points
• Viewing Alarms
• Viewing Events
• Viewing Administrator Activity
In this chapter:
Monitoring the Controller System
This section provides information on how to view information about the status of the controller
system, including its cluster planes and cluster events. It also describes how to use the chassis
view and to start the cluster monitor.
Topics covered include:
Viewing the System Cluster Overview
The system cluster overview provides summary information about the cluster name,control
planes and data planes on the controller appliance, any outstanding cluster alarms, and the
latest cluster events.
• To view the system cluster overview, go to Monitor > System.
The System Cluster Overview page appears, as shown in Figure 166: The System Cluster
Overview page on page 301.
You can view the cluster name using the show cluster name command. You can also
change the cluster name using the cluster name <new cluster name> command.
However, you can change the cluster name in stand alone, two node, three node and four
node clusters on SCG-200 and vSZ-H.
SmartCell Gateway 200/Virtual SmartZone High-Scale for Release 3.4.1 Administrator Guide
300
Monitoring the System, Alarms, Events, and Administrator Activity
Monitoring the Controller System
To Next Page
Loading...
