• If, before the controller was upgraded to 2.5, statistics upload, CGF server binary files, reports,
and system configuration backup were configured to be uploaded to the same FTP server
but using different FTP accounts, then after upgrading to 2.5 or later version, the controller
will automatically create entries for those four FTP servers on the Configuration > Services
& Profiles > FTPpage.
• If, before the controller was upgraded to 2.5 (or later version), statistics upload, CGF server
binary files, reports, and system configuration backup were configured to be uploaded to the
same FTP server and using the same FTP account, then after upgrading to 2.5 (or later
version), the controller will automatically create one FTP server entry on the Configuration
> Services & Profiles > FTPpage. If one of the previous FTP server configurations included
a remote directory, the same remote directory will be applied to the new FTP server entry
and all data for backup will be uploaded to this remote directory.
• In previous builds, the remote directory option was available for the CGF server binary files
and reports. Statistics and system configuration backups did not have the remote directory
option.
Configuring Location Services
If your organization purchased the Ruckus Wireless SmartPositioning Technology (SPoT) location
service, the controller must be configured with the venue information that is displayed in the
SPoT Administration Portal. After completing purchase of the SPoT location service, you will be
given account login information that you can use to log into the SPoT Administration Portal. The
Admin Portal provides tools for configuring and managing all of your “venues” (the physical
locations in which SPoT service is deployed). After a venue is successfully set up, you will need
to enter the same venue information on the controller.
Adding an LBS Server
Follow these steps to add an LBS server to the controller for SPoT communication.
1. Log on to the SPoT Administration Portal.
2. On the Venues page, click Config next to the venue for which you want to configure Location
services.
3. In Controller Settings, take note of the values for the following:
• Venue Name
• Server Address
• Port
• Password
4. On the controller web interface, go to Configuration > Services & Profiles > Services
> Location Services.
5. Click Create New.
The Create New LBS Server form appears.
SmartCell Gateway 200/Virtual SmartZone High-Scale for Release 3.4.1 Administrator Guide
167
Configuring Services and Profiles
Configuring Location Services
To Next Page
Loading...
