5. To remove a capability, clear the check box next to it.
6. Click Apply.
A message appears, confirming that the role has been updated.
7. Click Yes to close the message.
You have completed editing an administrator role.
NOTE: The system-created administrator account and role, which is present by default on the
controller, cannot be edited.
Cloning an Existing Administrator Role
If you want to create a new administrator role with capabilities that are similar to an existing role,
cloning the existing administrator role may be the faster way to create that new role.
You have completed cloning an existing administrator role. Unless you want the new role to have
exactly the same capabilities as the original role, you may want to edit it. For the steps on editing
the role, refer to Editing an Administrator Role.
1. Follow these steps to clone an existing administrator role.
2. In the Administrator Roles section, locate the role that you want to clone.
3. Under the Actions column, click the icon that is in the same row as the role that you want
to clone.
A dialog appears and prompts you for the name that you want to assign to the clone role.
The default name is Clone of [Original Role Name].
4. Type a new name or leave the name as is.
5. Click Apply.
The page refreshes, and then the role that you created appears under the Administrator
Roles section.
Adding a RADIUS Server for Administrators
You can add a RADIUS server to authenticate administrators.
NOTE: If you want to use a primary and secondary RADIUS servers for authenticating
administrator, follow the steps in Using a Backup RADIUS Server for Authenticating Administrators.
You have completed adding a RADIUS server for authenticating administrators.
SmartCell Gateway 200/Virtual SmartZone High-Scale for Release 3.4.1 Administrator Guide
254
Managing Administrator Accounts
Cloning an Existing Administrator Role
To Next Page
Loading...
