SSIDs Supported in Release 3.0 and Above
Release 3.0 and above supports a specific set of SSID syntaxes, which may be different from
the syntaxes supported in other releases.
Table 52: Supported SSID syntax in 3.0 and above
Between 2 to 32 characters are supportedLengthWeb Interface and
CLI
Unsupported: ` and $(
Space is allowed, but it must include at least one
non-space character (" abc" is valid, however only
space such as " " is invalid).
Characters
NOTE: One Chinese word is regarded as three
special characters.
ZoneDirector SSID Syntax
The following sections describe the supported SSID syntax in the following SCG release version:
SSIDs Supported in Releases 9.8 and 9.7
ZoneFlex releases 9.8 and 9.7 support a specific set of SSID syntaxes, which may be different
from the syntaxes supported in other releases.
Table 53: Supported SSID syntaxes in ZoneFlex 9.8 and 9.7
Between one and 32 charactersLengthWeb Interface
All printable ASCII characters from space (32) to
~(126)
Supported
Characters
The space character (32) cannot be the first or
last character in the SSID. Otherwise, the following
error message appears:
can only contain between 1 and 32
characters, including characters
from ! (char 33) to ~ (char 126).
Exceptions
Between one and 32 charactersLengthCLI
All printable ASCII characters from space (32) to
~(126)
Supported
Characters
The space character (32) can be placed anywhere
in the SSID (including the beginning or end)
Exceptions
SmartCell Gateway 200/Virtual SmartZone High-Scale for Release 3.4.1 Administrator Guide
464
SCG SSID Syntax
SSIDs Supported in Release 3.0 and Above
To Next Page
Loading...
