Figure 29: The Create New Device Policy Service form
Viewing Device Access Policies
Device access policies help in identifying the type of client attempting to connect, and perform
control actions such as permit/deny, rate limiting, and VLAN tagging based on the device type.
Once a device access policy has been created, you can apply the policy to any WLANs or WLAN
groups for which you want to control access by device type.
Follow these steps to view a list of existing device access policies.
1. Go to Configuration>AP Zones.
2. Click the AP zone for which you want to view existing device access policies.
3. On the AP Zones submenu, click Device Policy.
The Device Policy Services page appears and lists all existing device access policies and
their basic settings are shown, including the:
• Name
• Description
• Default access (allow or block)
• Actions (that you can perform)
4. To view or update policy settings, click the policy name.
You have completed viewing device access policies.
Deleting Device Access Policies
Follow these steps to delete device access policies.
1. Go to Configuration>AP Zones.
2. Click the AP zone for which you want to create a device access policy.
3. On the AP Zones submenu, click Device Policy.
4. Locate the policy or policies that you want to delete.
5. Select the check boxes (first column) for the policies that you want to delete.
6. Click Delete Selected.
The policies that you selected disappear from the list. You have completed deleting device
access policies.
NOTE: If you are deleting a single policy, you can also click the icon (under the Actions column)
that is in the same row as the policy that you want to delete.
SmartCell Gateway 200/Virtual SmartZone High-Scale for Release 3.4.1 Administrator Guide
86
Managing Ruckus Wireless AP Zones
Working with Device Policies
To Next Page
Loading...
