DescriptionOption
Access Point: If you base the report upon this device resource, you must select
the name of the specific access point from the drop-down list. You can only
select one access point to include in the report.
Select the SSID or SSIDs that you want to include in the report. If you want to
include multiple SSIDs in the report, select the SSIDs from the drop-down list
SSID
one at a time. To delete an SSID that you selected previously, click the icon
next to the SSID.
If you do not select an SSID, all existing SSIDs that belong to the device resource
you selected in Device will be included in the report.
Select the radio (2.4G or 5G) that you want to include in the report. If you do not
select a radio, both 2.4G and 5G radios belong to the device resource you
selected in Device will be included in the report.
Radio
NOTE: You must select at least one resource. You can also select and define all
three available resources.
Continue to Step 3: Define the Time Filter on page 318.
Step 3: Define the Time Filter
Follow these steps to define the time filter to use in generating the report.
The time filter can be defined in the Time Filter section.
1. In Time Interval, select the interval at which to generate the report. Available time interval
options include:
• 15 Minutes
• Hourly
• Daily
• Monthly
2. In Time Filter, select the time or date period for which to generate the report. Depending on
the time interval that you set above, available periods include:
• Hours
• Days
• Months
NOTE: The controller uses this time interval-time filter combination to determine the period
from which to generate the report and how often to generate it.
Continue to Step 4: Define the Report Generation Schedule on page 319.
SmartCell Gateway 200/Virtual SmartZone High-Scale for Release 3.4.1 Administrator Guide
318
Working with Reports
Creating a New Report
To Next Page
Loading...
