Ruckus Wireless Virtual SmartZone - Appendix G: SCG SSID Syntax; Ssids Supported in Release 1.1.X

Appendix
G
SCG SSID Syntax
In this chapter:
• SSIDs Supported in Release 1.1.x
• SSIDs Supported in Release 2.1.x
• SSIDs Supported in Release 2.5.x
• SSIDs Supported in Release 3.0 and Above
• ZoneDirector SSID Syntax
• ZoneFlex AP SSID Syntax
The following sections describe the supported SSID syntax in the following SCG release versions:
SSIDs Supported in Release 1.1.x
Release 1.1.x supports a specific set of SSID syntaxes, which may be different from the syntaxes
supported in other releases.
Table 49: Supported SSID syntaxes in 1.1.x on page 462 describes the SSID syntaxes that are
supported in release 1.1.x.
Table 49: Supported SSID syntaxes in 1.1.x
Between 1 and 32 characters, including characters
from printable characters (ASCII characters space
(32) to ~ (126)
LengthWeb Interface
Supported
Characters
• A-Z
• a-z
• 0-9
• _space_!"#$%&'()*+,-./
• :;<=?@
• [\]^_`
• {|}
UnsupportedLengthCLI
UnsupportedSupported
Characters
SmartCell Gateway 200/Virtual SmartZone High-Scale for Release 3.4.1 Administrator Guide
462
SCG SSID Syntax
SSIDs Supported in Release 1.1.x