3. After you complete the setup of one node, log on to the web interface of that node as a
system administrator.
4. Go to Administration > Configuration Backup and Restore.
5. In the Configuration Backups section, click the upload icon.
6. Locate the configuration backup file that you want to restore.
7. Click Upload.
After the configuration file is uploaded successfully, it appears in the Configuration Backups
section.
8. Restore the configuration backup to the node either using the web interface or the CLI.
9. To use the web interface:
a) Go to Administration > Configuration Backup and Restore page.
b) In the Configuration Backups section, locate the configuration backup file that you want
to restore.
c) Click the restore icon that is in the same row.
d) Follow the prompts (if any) to complete the restore process.
10. To use the CLI:
a) Log on to the CLI of the node as a system administrator.
b) Run the restore config command.
ruckus# restore config
This action will REBOOT the system. Do you want to only restore
this SCG node (yes/no)?yes
idx version date
------------------------------------------
1 1.1.1.0.93 2013-02-01 03:09:27 GMT
2 1.1.1.0.93 2013-02-03 07:21:24 GMT
Please choose a backup version to restore (ex: 1, 2, ...):2
c) When the configuration restore process on this node is complete, set up the next node
and configure it to join the existing cluster.
You have completed restoring configuration backup to multiple nodes in a cluster.
SmartCell Gateway 200/Virtual SmartZone High-Scale for Release 3.4.1 Administrator Guide
461
Replacing a Controller Node
Backing Up and Restoring Configuration
To Next Page
Loading...
