• Domain Name: Type the GGSN domain name.
• IP Address: Type the GGSN IP address.
7. Click Apply.
You have completed configuring the GGSN service.
Configuring an Authentication Profile
An authentication profile defines the authentication policy when the controller is used as a RADIUS
proxy service for WLAN. RADIUS protocol is used for interfacing between Access Points (AP)
and the controller as well as between the controller and a third party AAA (Authentication,
Authorization and Accounting) server. The controller acts as RADIUS proxy for authentication
and authorization and as a RADIUS client for accounting.
Follow these steps to create an authentication profile.
1. Go to Configuration > Services & Profiles.
2. On the sidebar under Profiles, click Authentication.
The Authentication Profiles page appears.
3. Click Create New.
The Create New Authentication Profile form appears.
4. In Name, type a name for the authentication profile that you are adding.
5. In Friendly Name, type a name that will be displayed as the authentication profile that you
are adding
6. In Description, type a brief description of the profile.
This is an optional field.
7. In Service Protocol, choose RADIUS setting.
This is the default setting.
8. RFC 5580 Out of Band Local Delivery: Select the Enable for Ruckus APs Only is check
box if you want AP location information for Ruckus Wireless APs to be included in RADIUS
accounting messages.
AP location information can be retrieved from the APs if their location information was entered
statically (for APs without GPS) or automatically acquired (for APs with GPS).
9. In the Primary Server section, configure the settings of the primary RADIUS server.
• IP Address: Type the IP address of the AAA server.
• Port: Type the port number of the AAA server. The default RADIUS server port number is
1812 and the default RADIUS Accounting server port number is 1813.
• Shared Secret: Type the AAA shared secret.
• Confirm Secret: Retype the shared secret to confirm.
10. In the Secondary Server section, configure the settings of the secondary RADIUS server.
SmartCell Gateway 200/Virtual SmartZone High-Scale for Release 3.4.1 Administrator Guide
389
Overview of the Captive Portal
Configuring the Captive Portal
To Next Page
Loading...
