a) Enable DHCP Relay: Select this check box to enable the DHCP relay agent in the
controller.
b) DHCP Server 1: Type the IPv4 address of the DHCP server that will allocate IP addresses
to DHCP clients.
c) DHCP Server 2: If a secondary DHCP server exists on the network, type the IPv4 address
of the secondary server.
d) DHCP Option 82: Select this check box if you want the DHCP relay agent (in this case,
the controller) to insert specific identification information into requests that are forwarded
to the DHCP server.
e) If you enabled DHCP Option 82, you can configure the following Option 82 suboptions
by selecting the corresponding check boxes:
• Subopt-1 with format: You can customize suboption 1 (Circuit ID) to send only the
AP’s MAC address in hexadecimal format or the MAC address and ESSID. The default
format is: IFName:VLAN-ID:ESSID:AP-Model:AP-Name:AP-MAC
• Subopt 2 with format: You can customize suboption 2 (Remote ID), which sends the
client’s MAC address by default, to send the AP’s MAC address, or the client MAC
plus ESSID or AP MAC plus ESSID.
• Subopt-150 with VLAN ID: This suboption encapsulates the VLAN ID.
• Subopt-151 with format: This suboption can encapsulate either the ESSID or a
configurable Area Name.
8. Click Create New.
You have completed creating an L2oGRE profile.
SmartCell Gateway 200/Virtual SmartZone High-Scale for Release 3.4.1 Administrator Guide
190
Configuring Services and Profiles
Working with Profiles
To Next Page
Loading...
