• Interim Accounting Interval (secs): Set the interim time interval for RADIUS clients to
send accounting updates. Default is 0, which indicates that the accounting interval is
disabled.
• Sessions Timeout (secs): Set a time limit after which users will be disconnected and
required to log on again.
• Session Idle Timeout (secs): Set a value in seconds (60 to 600) after which idle clients
will be disconnected.
b) Under PLMN ID Settings:
• Mobile Country Code: Set the correct country code for the geographical location.
This is required when the controller sends MAP authentication information to the HLR.
• Mobile Network Code: Set the mobile network code based on the geographical
location. This is required when the controller sends MAP authentication information to
HLR.
7. Under Realm Based Authentication Service, configure the following attributes, which are
required for enabling AAA support. These are also required when controller authentication
works as a proxy.
• Click No Match, and configure the following:
• Default Auth Service
• Authorization Method
• Dynamic VLAN ID
• Click Unspecified, and then configure the following:
• Default Auth Service: If you select NA-Request Rejected, then the authorization
method will be displayed as 'NA' but the value that will be sent is 0 (zero).
• Authorization Method
• Dynamic VLAN ID
8. In Authentication Service Per Realm, specify the authentication service for each of the
realms specified in this table. If you set the authentication service for a particular realm to
NA-Request Rejected, then the authentication request is rejected. To create a new service
click, Create New, and then configure the following:
• Realm
• Auth Service
• Authorization Method
• Dynamic VLAN ID
9. Click Create New.
You have completed adding an authentication profile.
SmartCell Gateway 200/Virtual SmartZone High-Scale for Release 3.4.1 Administrator Guide
172
Configuring Services and Profiles
Working with Profiles
To Next Page
Loading...
