2. On the sidebar under Profiles, click Hotspot.
The Hotspot Profiles page appears.
3. Click Create New.
The Create New Hotspot Profile form appears.
4. In the General Options section, configure the following options:
• Name: Type a name for the WISPr service.
• Description: Type a description for the WISPr service.
5. Configure the options in the Redirection section.
a) In Smart Client Support, select one of the following options:
• None: Select this option to disable Smart Client support in this hotspot.
• Enable: Selection this option to enable Smart Client support.
• Only Smart Client Allowed: Select this option to allow only Smart Clients to connect
to the hotspot. For more information, see Configuring Smart Client Support on page
279.
b) In Logon URL, type the URL of the subscriber portal (the page where hotspot users can
log on to access the hotspot portal).
For more information, see Configuring the Hotspot Logon URL on page 279.
c) In Start Page, set where users will be redirected after they log in successfully:
• Redirect to the URL that user intends to visit: You could redirect users to the page
that they want to visit.
• Redirect to the following URL: You could set a different page where users will be
redirected (for example, your company website).
6. In the User Session section, configure the following options:
• Session Timeout: Set a time limit (in minutes) after which users will be disconnected from
the hotspot portal and will be required to log on again.
• Grace Period: Set the time period (in minutes) during which disconnected users are
allowed access to the hotspot portal without having to log on again.
7. In the Location Information section, configure the following options:
a) Location ID: Type the ISO and ITU country and area code that the AP includes in
accounting and authentication requests.
The required code includes:
• isocc (ISO-country-code): The ISO country code that the AP includes in RADIUS
authentication and accounting requests.
• cc (country-code): The ITU country code that the AP includes in RADIUS authentication
and accounting requests.
• ac (area-code): The ITU area code that the AP includes in RADIUS authentication and
accounting requests.
• network
SmartCell Gateway 200/Virtual SmartZone High-Scale for Release 3.4.1 Administrator Guide
178
Configuring Services and Profiles
Working with Profiles
To Next Page
Loading...
