NOTE: The secondary/core interface IP address is must be configured manually; DHCP
is unsupported.
b) Subnet Mask: Enter the subnet mask for the IP address above.
c) VLAN: If you need to tag traffic with a VLAN ID, enter the VLAN ID number.
NOTE: If VLANS are configured on both the access and core networks, the VLAN ID that
you enter here must be different from the VLAN ID that you entered for the primary/access
interface.
NOTE: You cannot configure the IP address and VLAN settings for a virtual Data Plane from
the Primary (Access) and Secondary (Core) Interface sections.
Only vSZ-H supports virtual Data Plane.
8. Configure static route settings as follows:
a) Click Create New to create a new static route.
b) Enter the following information:
• Network Address: Enter the network IP address.
• Subnet Mask: Enter the subnet mask IP address.
• Gateway: Enter the IP address of the gateway router.
c) Click OK.
The static route settings are configured and displayed.
You can delete a static route by selecting the check box and clicking the icon.
9. Click Apply.
You have completed configuring the interface settings of a data plane.
SmartCell Gateway 200/Virtual SmartZone High-Scale for Release 3.4.1 Administrator Guide
228
Configuring the System Settings
Configuring Cluster Planes
To Next Page
Loading...
