3. In the Secondary Server section, fill out the IP Address, port number and shared secret
for the backup server (these fields can neither be left empty nor be the same values as those
of the primary server).
4. In the Failover Policy section, configure the following settings:
• Request Timeout: Type the timeout period (in seconds) after which an expected RADIUS
response message is considered to have failed.
• Max Number of Retries: Type the number of failed connection attempts after which the
controller will fail over to the backup RADIUS server.
• Reconnect Primary: Type the number of minutes after which the controller will attempt
to reconnect to the primary RADIUS server after failover to the backup server.
5. Click Apply.
You have completed adding primary and secondary RADIUS servers for authenticating
administrators.
SmartCell Gateway 200/Virtual SmartZone High-Scale for Release 3.4.1 Administrator Guide
257
Managing Administrator Accounts
Using a Backup RADIUS Server
To Next Page
Loading...
