DescriptionOption
the RADIUS NAS request timeout and max number of retries, see Administrator
Guide. For 3rd party APs, you must ensure that the configured Response
Window on the controller is higher than the RADIUS NAS request timeout
multiplied by the RADIUS value. The maximum number of retries is configured
at 3rd party controller/ AP.
12. Configure the Rate Limiting options.
• Maximum Outstanding Requests (MOR): Set the maximum outstanding requests per
server. Type 0 to disable it, or set a value between 10 and 4096. When the MOR value is
reached, RADIUS messages are dropped and a corresponding event is triggered.
• Threshold (% of MOR): Set a percentage value of the MOR at which (when reached) the
controller will generate an event. For example, if the MOR is set to 1000 and the threshold
is set to 50%, the controller will generate an event when the number of outstanding requests
reaches 500.
• Sanity Timer: Set a timer (in seconds) that the controller will use to assert event 1301.
When the load condition drops below the configured Threshold value (above), the controller
will wait for the sanity timer to elapse before asserting event 1301.
13. Group Traffic Profile Mapping: Fill in this field only if you are creating a user role based on
Group attributes extracted from an Active Directory or LDAP server
Enter the User Group name here. Active Directory/LDAP users with the same group attributes
are automatically mapped to this user role.
14. Click OK at the bottom of the form.
You have completed adding an authentication profile.
Figure 248: The Authentication Profile form
SmartCell Gateway 200/Virtual SmartZone High-Scale for Release 3.4.1 Administrator Guide
391
Overview of the Captive Portal
Configuring the Captive Portal
To Next Page
Loading...
