Ruckus Wireless Virtual SmartZone - Page 431

PurposeConfigurable
from Web
Interface?
To (Listener)From
(Sender)
Layer 4
Protocol
Port
Number
Access to the SCG/vSZ/SZ
web interface via HTTPS
NovSZ
management
plane
AnyTCP8443
GRE tunnel
NOTE: Only applicable to
SCG.
NoSCG (data
plane)
APTCP23232
GRE tunnel (required only
when tunnel mode is GRE
over UDP)
NOTE: On the vSZ-D, this
port is used for both data
YesData planeAPUDP and
TCP
23233
and control in both UDP
and TCP.
LWAPP discovery
NOTE:
If your AP is within the same
subnet as the controller,
NovSZ control
plane
APUDP12222/12223
disable nat-ip-translation to
establish a connection
between the AP and the
controller so that AP
firmware upgrade
progresses.
If your AP is on the side of
the NAT server and if the
NAT server does not
support PASV-Mode FTP,
enable nat-ip-translation. If
the NAT server supports
PASV-Mode FTP, then
disable nat-ip-translation for
AP firmware upgrade to
progress
SmartCell Gateway 200/Virtual SmartZone High-Scale for Release 3.4.1 Administrator Guide
431
AP-SCG/SZ/vSZ/vSZ-D Communication