Ruckus Wireless Virtual SmartZone - Page 56

• Windows Domain name: Type the domain name for the Windows server
• Admin Domain Name: Type the domain name for the administrator.
• Admin Password: Type the administrator password.
• Confirm Password: Re-type the password to confirm.
• Base Domain Name: Type the namde of the base domain.
• Key Attribute: Type the key attribute such as UID.
• Search Filter: Type filter by which you want to search such as objectClass=*
5. In the Secondary Server section, configure the settings of the secondary RADIUS server.
NOTE: The Secondary Server section is only visible if you selected the Enable backup
RADIUS server check box earlier.
• IP Address: Type the IP address of the secondary AAA server.
NOTE: The format of the IP address that you need to enter here depends on the AP IP
mode that you selected when you created the AP zone (see Creating an AP Zone). If you
selected IPv4 Only, enter an IPv4 address. If you selected IPv6 Only, enter an IPv6
address. Ensure that the IP address of the AAA server is the same in the primary server
and the secondary server.
• Port: Type the port number of the secondary AAA server port number. The default RADIUS
server port number is 1812 and the default RADIUS Accounting server port number is
1813.
• Shared Secret: Type the AAA shared secret.
• Confirm Secret: Retype the shared secret to confirm.
6. Click Create New.
You have completed creating an AAA server for the AP zone.
SmartCell Gateway 200/Virtual SmartZone High-Scale for Release 3.4.1 Administrator Guide
56
Managing Ruckus Wireless AP Zones
Working with AAA Servers