9
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
REPLACEMENT OF PC BOARDS/HDD
9 - 43
[B] Initialize SRAM board
(1) Pull up the duplexing unit, and check the destination printed on the white tape stuck on the
equipment.
(2) Start up with the Setting Mode (08).
(3) Enter the password, and then press the [OK] button.
(If the password is not set for Service, press the [ENTER] button without entering anything.)
(4) Perform “Destination display at SRAM initialization” (08-9060).
(5) Check whether the displayed destination (see the below figure) of the SRAM board (for the SYS
board) is the same as the one in step (1).
Fig. 9-70
Remarks:
If the destinations are different, initialize the SRAM board (for the SYS board) with reference to
the following procedure.
P. 9-35"9.2.6 Precautions and Procedures when replacing SRAM board (for SYS board)"
(6) Perform “Printer all clear” (08-9090).
To Next Page
Loading...
