Toshiba e-STUDIO 6550Ce-STUDIO 5560C - Page 442

e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY and REPLACEMENT
4 - 268
4.11.14 Feed roller
(1) Take off the paper feeder unit.
 P. 4-266"4.11.12 Paper feeder unit"
(2) Remove 1 clip. Then slide the pulley and
remove 1 pin.
Fig. 4-781
(3) Pull out the shaft and take off the feed roller.
Fig. 4-782
Notes:
Make sure you assemble the pickup roller
with the one-way clutch in the correct
direction.
Fig. 4-783
Lock
Lock