Toshiba e-STUDIO 6550Ce-STUDIO 5560C - Page 658

e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
SETTING ADJUSTMENT
6 - 110
(5) Remove 1 screw each, and take off front and rear screw cover[1].
Fig.6-81
(6) Insert the “F/R” side of the separation plate gap confirmation jig into the window closest to you of
the separation plate [1].
(7) Adjust the gap with the adjustment screw until the 0.5 mm section of the jig is inserted without
touching, but its 0.8 mm section contacts the separation plate.
(8) Insert the “F/R” side of the jig [2] into the window of the separation plate [1], which is farthest
away from you, and then adjust the gap.
(9) Insert the “C” side of the jig [2] into the window at the center of the separation plate [1].
(10) Adjust the gap with the adjustment screw until the 0.7 mm section of the jig [2] is inserted without
touching, but its 1.0 mm section contacts the separation plate surface.
(11) Install the screw covers removed in step (5).
Notes:
If the screw covers do not fit the screws, slightly turn them either clockwise or counterclockwise.
Fig.6-82
[
1
]
[
1
]
[1]