EasyManua.ls Logo

Toshiba e-STUDIO 6550Ce-STUDIO 5560C - Page 957

Toshiba e-STUDIO 6550Ce-STUDIO 5560C
1499 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
ERROR CODE and TROUBLESHOOTING
8 - 201
* AccessFailed or KeyMismatch
[F109_5] Key consistency error (encryption key for ADI-HDD is damaged)
Take measures given in the following table according to the messages displayed in the SRAM Key
Status and FROM Key Status fields.
Remarks:
If the error is not cleared, reinstallation of the system firmware, system software and application
is needed. ([4]+[9] Power-ON)
KeyMismatch KeyMismatch <The error occurs when the SYS board is replaced>
Recover the license on the SYS board. (Transfer the license
from SYS-SRAM to SYS-FROM.)
P. 9-30"9.2.4 Precautions and Procedures when replacing
the SYS board"([G]Restore license)
<The error occurs except when the SYS board is replaced>
Recover the license on the SRAM board. (Transfer the license
from SYS-FROM to SYS-SRAM.)
P. 9-35"9.2.6 Precautions and Procedures when replacing
SRAM board (for SYS board)"([I]Backup license)
Classification Contents
Other service call Key consistency error - Encryption key for ADI-HDD is
damaged.
Check item Measures
Encryption key status confirmation Check the message displayed by [3] + [C] + [POWER] 5. Key
Backup Restore.
SRAM Key
Status
FROM Key
Status
Measure
* AccessFailed Replace the SYS board.
P. 9-30"9.2.4 Precautions and Procedures when replacing
the SYS board" (all steps)
<With USB backup data: All key data recovery>
1. Recover all the data on the SRAM board.
[5] + [9] + [POWER] 2. Restore SRAM Data from USB
(For details, see “12.1.4Cloning procedure [B]Restore
procedure”.)
2. Recover the encryption key/license on the SYS board.
Follow the procedures below noted in “9.2.4Precautions and
Procedures when replacing the SYS board”.
[E] Restore ADI key (only when ADI-HDD is installed)
[F] Restore encryption key
[G]Restore license
AccessFailed * Replace the SRAM board (for the SYS board).
P. 9-35"9.2.6 Precautions and Procedures when replacing
SRAM board (for SYS board)" (all steps)
OK KeyNull/
KeyBroken
Recover the ADI key on the SYS board.
P. 9-30"9.2.4 Precautions and Procedures when replacing
the SYS board" ([E]Restore ADI key)
SRAM Licence
Status
FROM Licence
Status
Measure

Table of Contents

Related product manuals