3Com 5500G-EI - 5 USING NETWORK PROTOCOL COMMANDS; IP Address Configuration Commands; ARP Configuration Commands

5
USING NETWORK PROTOCOL
COMMANDS
This chapter describes how to use the following commands:
IP Address Configuration Commands
■ display ip host
■ display ip interface
■ ip address
■ ip host
ARP Configuration Commands
■ arp check enable
■ arp static
■ arp timer aging
■ debugging arp packet
■ display arp
■ display arp timer aging
■ reset arp
Resilient ARP Configuration Commands
■ debugging resilient-arp
■ display resilient-arp
■ resilient-arp enable
■ resilient-arp interface vlan-interface
BOOTP Client Configuration Commands
■ debugging dhcp xrn xha
■ ip address bootp-alloc
DHCP Client Configuration Commands
■ debugging dhcp client
■ debugging dhcp xrn xha
■ display dhcp client
■ ip address dhcp-alloc
DHCP Relay Configuration Commands
■ address-check